• Elcometer 456 Miniature Probe Operating Instructions. Warning The Elcometer 456 gauge uses a Liquid Crystal Display.

If it is heated above 50° C (120° F) it may be damaged. This can happen if it left in a car parked in strong sunlight. • CONTENTS Section Page Introduction..2 Operating Instruction.

• They can be used on anodising, paint, plastic coatings, powder, etc applied to aluminium, brass, non-magnetic stainless steel, etc. The package for the 456 miniature probe contains the scale 3 miniature probe, FM3 or NM3, and an appropriate set of measured foils. • 2 OPERATING INSTRUCTION When fitting the FM3 miniature probe to the Elcometer 456 gauge ensure that the gauge is switched off before the old probe is removed and the new probe fitted.

Elcometer are leaders in coating & concrete inspection equipment, rebar & metal detection. Our products measure coating thickness, climate, porosity & adhesion as. Material Safety Data Sheets for the Elcometer 138 Calibration. These operating instructions complement the operating instructions supplied with the Elcometer.

Torrent Summitsoft Logo Design Studio Pro. This allows the data stored in the probe to be read. • When a new type of probe is fitted to the Elcometer 456 gauge the gauge factory reset feature should be used to set the gauge to the calibration conditions set in the memory of the probe during its final test in the factory. • Full details of the calibration adjustment methods available on the Elcometer 456 gauges are given in the Elcometer 456 operating instructions. To activate the calibration adjustment procedure select CAL from the READING SCREEN. The gauge will show full instructions with graphical and text support.

• 0.1 mil from 4 - 10 mil is the greater Measured with the probe held in a placement jig, using measured foils and the Elcometer zero plate. 1% accuracy is achieved when calibrating close to the coating thickness value to be measured.